devd doesn't listen if livewatch is specified

[polm]

I have devd 0.9 on Arch Linux, installed via the AUR. I usually use devd like this:

devd -a -l -p 8000 ~/site/

After updating devd recently it stopped working; devd would start up but I couldn't connect. I played around with flags and it seems like if I use the -l switch it never starts listening on a port (checked with lsof). The only output is Route / -> reads files from ....

If take away the -l flag it starts listening as usual.

Am I doing something wrong?

[polm]

Fiddling around more found something strange. The above command doesn't work, but this does:

cd ~/site/
devd -a -l . -p 8000

It seems to consistently work if the path is . but not if it's a directory. When it doesn't work, it also uses 100% CPU.

[wader]

Maybe run with strace could help see what is going on strace -f devd .... Look for bind failure, going thru lots of files etc

[polm]

Ah, yeah, it's going through tons of files,

If the directory structure is like this:

/home/person/site

Suppose cwd is /home/person and command is devd -l ./site. I would expect it to only access files in site but it seems to be checking all the files in /home/person.

Is that correct behavior? It seems wrong to me...

[wader]

Did some digging. I suspect that #95 caused devd to always add a watch for the current working directory, the ** include pattern i think will make moddatch.Watch add it as base dir.

If you are able to build devd yourself you could try to remove the "***" part and see if it behaves better.

@cortesi Could this be the case? as i understand in the end devd will add recursive watches for all base dirs? will that case lots of file system traversal?

[polm]

Sorry, I'm not familiar enough with go to build devd. (I was able to install go and run go build but it produced no bianries...?)